See: KO Propo

Coming soon from KO Propo is the Electrical Switch 3. This electrical controled power switch unit features a CPU which remembers the current power state On/Off. It prevents the power supply from turning off due to poor contact of the connector by the vibration in the engine car or momentary or voltage drop at overload. Voltage is displaied by seven segment LED to easily see the battery voltage monitoring. The current battery voltage is displayed for 5 seconds one the power is turned On. After 5 seconds, the minimum voltage is always displayed so the voltage at the time of the voltage drop during running can be easily confirmed.

The Electrical Switch 3 features a LiPo mode for safety when using. This function prevents battery breakage due to voltage drop when using 2 cell Li-Po battery (7.4V). When the battery voltage falls below 6.6V for 2 seconds, this product cuts output in the circuit and protects the battery. Also, when the battery voltage again exceeds 6.6V, output resumes automatically. The Electrical Switch 3 uses an electronic On/Off switch which has high durability against vibration and shock, so it avoids the contact failure which could occur in the conventional slide switch, supply is possible. The CPU remembers the current power state On/Off. It prevents the power supply from turning off due to poor contact of the connector by the vibration in the engine car or momentary or voltage drop at overload. The translucent case allows to judge the On/Off state of the power supply from the side of the switch. Also, Li-po mode state as like as too.

Specifications:

  • Input voltage: Minimum 5.0V/Maximum 10.0V
  • Instant maximum current: 14.0A
  • Continuous maximum current: 8A
  • Current by self consumption: Maximum 1mA in standby (when all of 7 segment LED lights maximum 10mA)
  • Dimensions: 39.2×17.5×9.5mm (Excluding protrusions)
  • Cable length(input/Battery): 80mm
  • Cable length(Output/Receiver): 180cm
  • Weight: 10.0g